Solar Charge Controller MPPT 30A 40A 50A 60A 80A 100A LCD Display 12V 24V AUTO Dual USB Solar Charge And Discharge Controller

SPECIFICATIONS:

HIGHLIGHTS:

• Industrial-grade master chip, 16 AD sampling accuracy, temperature, charging current, discharge current accurate real-time display, power generation at a glance.

• Automatic focusing MPPT tracking charging, high charging efficiency, non-stop detection during charging, bidirectional focusing tracking.

• A complete three-phase charge management, effectively protect the battery, the battery is more durable.

• Large-screen LCD display, adjustable charging and discharging parameters. UItra-wide charge and discharge adjustable, as long as you understand the characteristics of the battery set its corresponding charging parameters, you can charge a battery. When the output is off, the time can be adjusted, which is more convenient. (on the market, there is no point adjustment)

• Bidirectional MoS tube anti-backflow circuit, high-power charging mode, ultra-low heat.

• Built-in overheating, overcurrent short circuit, open circuit protection, reverse connection protection when the fault is eliminated, the controller automatically recovers, does not damage

  the device.

• R5. 0 solar charging DC plug, R5. 0 DC lamp output DC plug, convenient connection.

PACKAGE LISTS:

• 1 x Solar Panels Battery Charge Controller
• 1 x User Manual

NOTE:

• This controller is 12V/24V automatic adaptation. When installing for the first time, please make sure that the battery has enough voltage for the controller.
• Install the controller as close to the battery as possible to avoid the voltage drop caused by the excessive length of the wire, which affects the normal voltage judgment.
• The controller can be used for lead-acid batteries and lithium batteries. If you charge a lithium battery, you must set the charging parameters after connecting to the power source. Please refer to the manual for details.
• The controller can only use photovoltaic panels as the charging source, do not use DC or other power sources as the charging source.
• When the controller is running, it will heat up. Please be careful to install the controller on a flat, well-ventilated surface.